Product Introduction: The horizontal vibration fluidized bed dryer enters the material from the feeding port into the machine, and under the excitation force provided by the vibration motor or other means, it jumps forward on the air distribution plate. At the same time, the air is filtered and heated to a certain temperature, and enters the lower air chamber of the dryer through the air outlet. Under the dual action of the vibration force and the hot air flow evenly distributed through the air distribution plate, the material is suspended and in contact with the hot air flow, The intense turbulence between the material particles and the hot medium strengthens the heat and mass transfer process. The dried products are discharged from the discharge port. The evaporated water and waste gas are discharged into the atmosphere after the dust is recovered by the cyclone separator. The lower bed provides a stable and pressurized air chamber for the bed layer. Adjust the induced draft fan to maintain a slight negative pressure on the upper part of the bed material in the upper box, maintain a good dry environment, and prevent dust leakage.

Applicable materials: Suitable for drying and cooling powder materials in industries such as food, chemical, pharmaceutical, feed, plastic, salt making, grain, seed, tobacco, sugar, metallurgy, etc.

Performance characteristics:

1. Energy saving: Due to the jumping movement of materials along the orifice plate, they come into full contact with hot air, resulting in high thermal efficiency.

2. Widely used: Changing the excitation force and installation direction angle of the vibration motor can change the operating speed and motion state of materials, making it suitable for drying or cooling different materials.

3. Good drying effect: Vibration causes the material to be in a jumping state, and hot air can play a buffering role from below, resulting in low material crushing rate, less wear, and no overheating or leakage phenomenon.

4. Low noise, good vibration isolation: The equipment can be floating on the floor for work, easy to install and move, well sealed, and has a good working environment.

If a partition is added in the middle of the tank, with hot air in the front section and cold air in the rear section, both drying and cooling functions can be achieved.

6. Low investment and low operating costs. Simple structure, sturdy and durable, easy to maintain, and lightweight.

7. It can be equipped with an automatic feeding device for continuous and uniform feeding, forming an automatic flow production line.

On site photos:

Process flow:

1. Air supply fan 2, heater 3, feeder 4, hose 5, exhaust pipe 6, temperature gauge (2 pieces) 7, dust collector8. Suction duct 9, suction fan 10, discharge outlet 11, dryer 12, supply duct

Process flow description: Due to the excitation force generated by the two vibration motors installed on the main body, the material jumps forward along the horizontal orifice plate; The hot air passes through the orifice plate from the bottom up and passes through the material layer to achieve the purpose of dehydration and drying.

Performance Table: